| |
Take time to practice before
driving on main roads and never allow anyone to ride
in or on the trailer. Before you leave, remember to
check routes and restrictions on bridges and
tunnels. Consider the following safety tips each
time you drive with a trailer.
General Handling
- Use the driving gear that the manufacturer
recommends for towing.
- Drive at moderate speeds. This will place
less strain on your tow vehicle and trailer.
Trailer instability (sway) is more likely to
occur as speed increases.
- Avoid sudden stops and starts that can cause
skidding, sliding, or jackknifing.
- Avoid sudden steering maneuvers that might
create sway or undue side force on the trailer.
- Slow down when traveling over bumpy roads,
railroad crossings, and ditches.
- Make wider turns at curves and corners.
Because your trailer’s wheels are closer to the
inside of a turn than the wheels of your tow
vehicle, they are more likely to hit or ride up
over curbs.
- To control swaying caused by air pressure
changes and wind buffeting when larger vehicles
pass from either direction, release the
accelerator pedal to slow down and keep a firm
grip on the steering wheel.
Braking
- Allow considerably more distance for
stopping.
- If you have an electric trailer brake
controller and excessive sway occurs, activate
the trailer brake controller by hand. Do not
attempt to control trailer sway by applying the
tow vehicle brakes; this will generally make the
sway worse.
- Always anticipate the need to slow down. To
reduce speed, shift to a lower gear and press
the brakes lightly.
Acceleration and
Passing
- When passing a slower vehicle or changing
lanes, signal well in advance and make sure you
allow extra distance to clear the vehicle before
you pull back into the lane.
- Pass on level terrain with plenty of
clearance. Avoid passing on steep upgrades or
downgrades.
- If necessary, downshift for improved
acceleration or speed maintenance.
- When passing on narrow roads, be careful not
to go onto a soft shoulder. This could cause
your trailer to jackknife or go out of control.
Downgrades and
Upgrades
- Downshift to assist with braking on
downgrades and to add power for climbing hills.
- On long downgrades, apply brakes at
intervals to keep speed in check. Never leave
brakes on for extended periods of time or they
may overheat.
- Some tow vehicles have specifically
calibrated transmission tow-modes. Be sure to
use the tow-mode recommended by the
manufacturer.
Backing Up
- Put your hand at the bottom of the steering
wheel. To turn left, move your hand left. To
turn right, move your hand right. Back up
slowly. Because mirrors cannot provide all of
the visibility you may need when backing up,
have someone outside at the rear of the trailer
to guide you, whenever possible.
- Use slight movements of the steering wheel
to adjust direction. Exaggerated movements will
cause greater movement of the trailer. If you
have difficulty, pull forward and realign the
tow vehicle and trailer and start again.
Parking
- Try to avoid parking on grades. If possible,
have someone outside to guide you as you park.
Once stopped, but before shifting into Park,
have someone place blocks on the downhill side
of the trailer wheels. Apply the parking brake,
shift into Park, and then remove your foot from
the brake pedal. Following this parking sequence
is important to make sure your vehicle does not
become locked in Park because of extra load on
the transmission. For manual transmissions,
apply the parking brake and then turn the
vehicle off in either first or reverse gear.
- When uncoupling a trailer, place blocks at
the front and rear of the trailer tires to
ensure that the trailer does not roll away when
the coupling is released.
- An unbalanced load may cause the tongue to
suddenly rotate upward; therefore, before
un-coupling, place jack stands under the rear of
the trailer to prevent injury.
|
|
| |
|